Recently, the MRCA (Midwest Roofing Contractors Association) issued a warning bulletin regarding TPO roof failures caused by the sun’s UV rays. You can read more about it in our original TPO Roofing page, as well as my commentary on this bulletin.
At the same time, major roofing distributors are shamelessly pushing TPO into the market and onto the roofing contractors without much regard for home and building owners. Bear in mind that because of low prices and “same cool roof” and “welded seams” qualities as PVC roofing has, TPO is now the fastest growing commercial roofing product.
TPO Roofing Product for Residential Contractors
Here is a good example – pictures below will show you “manufacturer’s” stand showing a TPO roof designed for residential roofing contractors.
Why residential roofing contractors? Well, the way I was told, these are the roofers who can’t afford to spend $12,000 on hot-air welding equipment, so the roof manufacturer created a system that would allow these guys to jump on the TPO band-wagon.
(The TPO stand above, is displaying outside corner flashing, inside corner flashing, pipe boot, and drip-edge details. When I asked about the caulking along the seams, i was told it’s not caulking. It’s seam tape 🙂 )
Here comes the best part! This TPO roof system is put together with … no, not hot air. Seams are primed and a seam tape is used to seal overlaps! 😀 But, it gets better – since there is no uncured flashing material in the TPO world, and these “shingle-bangers” don’t have Liesters (hot air welders) nor do they want to buy them, since the cheapest one – a hand welder – is $450 before tax. So, this manufacturer uses white EPDM uncured flashing for all detail work such as inside / outside corners, posts, curbs (skylights, chimneys, roof hatches, HVAC equipment, etc.). EPDM rubber on TPO – really?