Recently we finished installing an aluminum standing seam metal on a residential home in Wayland, Massachusetts. The roof is made of .032 Aluminum, coated with grey finish Kynar 500 coating. It is a 1.5″ snap-lock standing seam, attached with stainless steel clips and wood screws. Also, as you can see, there is a rail snow retention system, which I will describe in detail below. It consists of cast-aluminum mounts attached to ribs of the standing seam roof and two rows of stainless steel cross bars (rails) to hold snow and ice from sliding off the roof.
Originally, the homeowner was having bad problems with Ice dams and leaks. Originally, the roof had an “ice belt” made of copper, but it only covered the bottom 2 feet of the roof and as we discovered later, during tear-off, it was tucked under the shingles above it by only 2-3 inches. Needles to say, this copper ice-belt did not work as it was intended to, and the ice dams were still creating leaks. After a while, to solve the Ice Dams problem the homeowner installed large sheets of aluminum.